A Banner Of Thanks

 After a year of looking at a stack of large triangles I cut out last year (right before I had hand surgery) for this banner, it was time to actually make the Thankful Banner. 
The size of the triangles I cut out was 10.25" at the base and 13.75" tall.
Since this is to be a double-sided banner, I cut out the number of triangles I needed to spell out GIVE THANKS twice, including one for the space inbetween the two words, which worked out to 22.
Each triangle was cut from a different fall fabric, leaves, greens, browns, corn, trees, pumpkins, etc. 
I had to choose some fabrics to use for the letters.  I decided to go with oranges and yellows so they would show up against the fall colors

 I chose a font that I really liked  the look of (Lucida Handwriting) and printed the letters out in a huge size (350pt).  About two letter per page printed out.  I wanted lots of room around the letter on each triangle.  For this type of project you want a fairly simple letter shape that isn't going to kill you cutting it out and sewing it down. 

 Whoops, I should have printed them out reversed since I was doing the fusible tracing thing. 

 So instead of wasting paper,  I quickly traced around the back of each letter in sharpie pen, so that I could then do the next step.  Learn from my mistake if you do this *print in reverse*.

Traced the (now backwards) letters onto fusible web (Steam a Seam 2). 

 Rough cut out the fusible letters, then fused them to the back of the letter fabrics. 

 Cut alllll those letters out of the now-fused fabric.

Next step was to fuse the letters down onto each triangle.  I decided I wanted them to be in roughly the same spot on each triangle so some measuring was required. Take into account seam allowances and the top inch which will be folding over the ribbon or cord.  Also be sure that the letter fabric shows up well enough from your background fabric. I had a few that I had to switch around to make it work well.

I used a tearaway iron-on stabilizer (Tearaway Magic) which I ironed to the back of each triangle covering the area where the letter was to be sewn down.

Stitched in a zig-zag around each letter.  I was going to do a satin stitch but decided I liked how this looked, and the banner won't be something that I'm washing all the time, so the edges should hold up pretty well.

Here's how the back of the triangle looks after I've sewn down the letter S.

After all the letters were sewn down I matched each triangle up with their mates.  This part can be tricky if you want your banner to be spelled correctly on both sides. So check your work several times. 

Sew the two triangles together right sides together starting about an inch down from the top edge. 

Cut the tips seam allowances down like the picture above.  

Turn the piece right-side out, use a chopstick to poke out the pointy tip and smooth out the seams, press. 

Press in the seam allowance on the remaining 1" up the top edge. 

Fold in about 1/2" and press the two top edges,  to make a casing.

Sew across the top edge and also about 1" down from the top edge.

Do a final press, string onto cord or ribbon. And There it is! Done and hanging in our house!

Too many banners? Yep, adding one to the usual two that are hung in our house did muddy the waters a bit.  Maybe next year I'll just have one up there at a time.